Roadway Safety Foundation's Roadway Safety Guide is a Primer for Community Leaders on enhancing road features for the safety of motorists, pedestrians and bicyclists. Guide contains info on funding, best practices and checklists.
Issue link: http://www.e-digitaleditions.com/i/418038
23 Case Studies & Best Practices guardrails, ditches, or bridge supports; they may also roll over. Two aspects of this national safety problem are particularly challenging: keeping drivers on the road and protecting drivers when they do leave the road. Community leaders should work with their transportation professionals to tackle both the prevention and mitigation of crashes. An investigation of the reasons for roadway departures in a given area, and an assessment of the impact of collisions with roadside obstacles are essential for devising an appropriate strategy for improving safety. KEEPING DRIVERS ON THE ROAD – CENTERLINE RUMBLE STRIPS IN ARKANSAS Overview Highway 7, a rural, two-lane road in north central Arkansas, had been experiencing a particularly high crash and fatality rate due to its location in a mountain- ous national forest and its frequent curves. However, a statewide effort to install 382 miles of rumble strips on major multi-lane routes provided the perfect opportunity to undertake a cost-effective and efficient project: installing centerline rumble strips on a 74-mile stretch of Highway 7. At a cost of only 15 cents per linear foot, Arkansas was able to add low-cost protection for vehicles traveling this scenic route. Results The project was evaluated using crash data from the three-year period before the centerline rumble strips were implemented, and the three years immediately following installation. The results were impressive: head-on and opposite-direction sideswipe crashes dropped 56 percent, from 25 to 11, and fatal crashes fell 64 percent, from 11 to four. There was a 41 percent reduction in all crashes, and the initial price tag for the project of $59,000 translated into an annual economic benefit of $3.7 million due to crash, injury, and fatality reductions. THE MIDWEST GUARDRAIL SYSTEM Overview Traditional W-beam guardrails, standard on American roadways since the 1960s, were shown in the 1990s to provide inadequate protection for light trucks and vehicles with high centers of mass. 21 Light trucks have a greater chance of going through such guardrails, or of rolling over after striking them. 21 From research and modeling that began in 2000, the Midwest Roadside Safety Facility (MwRSF) concluded that modest changes to the existing design could achieve dramatic safety gains and, together with the Midwest states Pooled Fund Program, developed the Midwest Guardrail System (MGS). In comparison with the traditional design, the MGS features a four-inch rail height increase, a four-inch increase in blockout depth, and splices in the midspan of the rails rather than at the posts. 21 Results Through crash testing, the MGS has been shown to have more than twice the capacity of conventional guardrails. In addition to stopping light trucks suc- cessfully, the MGS is less susceptible to rupture, and vehicles impacting it remain close to the guardrail rather than ricocheting back into traffic. This reduces the likelihood of secondary crashes, and keeps the vehicle involved in a safer resting place. As a result of this improved performance and the system's modest cost, more than a dozen states are in the process of imple - menting the MGS in place of the traditional designs. The initial price tag for the project of $59,000 translated into an annual economic benefit of $3.7 million.

