Roadway Safety Foundation's Roadway Safety Guide is a Primer for Community Leaders on enhancing road features for the safety of motorists, pedestrians and bicyclists. Guide contains info on funding, best practices and checklists.
Issue link: http://www.e-digitaleditions.com/i/418038
33 • Reducing rear-end, intersection, and side-swipe crashes; • Improving speed limit compliance and decreasing crash severity; • Reducing the number of lanes that pedestrians may have to cross without a refuge; • Improving safety for bicyclists; and • Providing more space for on-street parking. Roadway reconfigurations improve safety at mid-block locations where drivers tend to increase speed. More than 80 percent of pedestrians hit by vehicles traveling at 40 mph or faster will die, while less than 10 percent will die when hit at 20 mph or less. Roadway reconfigurations can be done at low cost if planned in conjunction with reconstruction or simple overlay projects, or if the project mostly consists of restriping. Driveway density, transit routes, the pres - ence of trucks, the number and design of intersections along the corridor, and operational characteristics are some considerations to be evaluated before deciding to implement a new roadway design. It is important to analyze and understand the effects of the proposed change, obtain input from stakeholders, and ensure the appropriate elements are included in the project. Improvements to intersection turn lanes, signing, pavement markings, traffic control devices, transit stops, and pedestrian and bicyclist facilities may be needed to support this concept. It should be noted that many roadway reconfigurations are compatible with roundabouts. One example of a successful roadway reconfiguration is in University Place, Washington. A section of Bridgeport Way was the site of more than 300 crashes in a two year span: 10 involved pedestrians and 91 resulted in injuries. There were no sidewalks or bicycle lanes, lighting was sporadic, and speeding, multiple access points, and narrow gravel shoulders added further dysfunction. Bridgeport Way is a significant regional arterial con - necting Interstate 5 to State Route 16. Approximately 25,000 vehicles per day and a major transit route use the corridor. Before improvements, the 1.5 mile section that bisects University Place's main commer - cial area had five undivided traffic lanes (two in each direction and a shared center turn lane) with narrow gravel shoulders. After obtaining a grant from the Washington State Transportation Improvement Board, this section of Bridgeport Way was reconstructed in three phases over two years. The new design maintained the four through travel lanes and replaced the center two-way left turn lane with a raised, landscaped median with lights. Planter strips along the corridor include streetlights that match the median lights, and bicycle lanes and sidewalks were installed on both sides of the road. Other improvements included mid-block pedestrian crossings with overhead signals and flared intersections to accommodate U-turns, which reduced crashes and improved access to businesses. Results On Bridgeport Way, the reconfiguration along the corridor resulted in lower speeds and fewer mid-block collisions. Crashes have been reduced by about 60 percent and average traffic speeds by about 13 percent. Despite greater pedestrian activity and exposure to vehicle traffic, pedestrian crashes did not increase. Roadway Design Limitations Many local roads were not built to serve today's high-volume, high-speed traffic. Their safety is limited by hazards such as sharp curves, poor signs and pavement markings, and lack of medians to separate oncoming traffic. For these reasons, two-lane rural roads see fatality rates two-three times higher than the nation's safest roadways, our Interstates. 12 Principles of good road design are generally well-understood: we know, for example, that rumble strips Case Studies & Best Practices

