Machinery Lubrication

Machinery Lubrication September October

Machinery Lubrication magazine published by Noria Corporation

Issue link: http://www.e-digitaleditions.com/i/730290

Contents of this Issue

Navigation

Page 50 of 69

44 | September - October 2016 | www.machinerylubrication.com ASK the EXPERTS An increase in hydraulic cylinder speed is a rare occurrence. To better understand the problem, let's consider the much more prevalent case of decreasing speed and apply the opposite logic. In terms of hydraulic systems, a reduction in performance is usually the first clue that a problem has manifested in the system. This is most often indicated by longer cycle times and slower operation. The root cause of these failure symptoms can frequently be traced back to fluid flow. The fluid flow in a hydraulic system determines actuator speed and quickness of response. Loss of flow will equate to loss of speed. Applying this same logic to an increased cylinder speed would mean that more flow is occurring. What could happen in a hydraulic system that would cause an increase in flow over time? Internal Leakage – If an internal leak becomes clogged, the flow would inher- ently increase. "Over the past several months, we have noticed that one of our hydraulic cylinders speeds up by itself intermittently. Would you have any idea as to why this is happening and if this is a common problem?" "Our gearbox, which leaks excessively, is close to the end of its life. It currently uses an ISO 680 EP oil, but we would prefer to use a lubricant that would stem some of the leakage and allow the gearbox to continue running until the next scheduled turn- around. What would you suggest?" When it comes to leakage, the only real solution is to take down the machine and repair it in order to stop the leak. As oil continues to flow from the gearbox, there are obvious safety concerns involved with exposing people and the envi- ronment to the gear oil. This also doesn't take into consideration the cost of the oil that is leaking. Synthetic oils can be very costly, and having a component that leaks these fluids is similar to throwing money down the drain. Provided that the component can be taken down and repaired in the near future, there are some options to "Band-Aid" the problem. Several manufacturers make compounds that can be added to the oil to help mitigate leakage. These compounds work along the same lines as radiator sealants that form deposits at the point of leakage. As with intro- ducing any aftermarket product to your oil, this should only be done after careful consid- eration and testing to ensure there will be no ill effects on the oil or machine. Other types of products that can be used are touted as seal enhancers. These fluids and pastes are manufactured with synthetic bases and will cause seal material to swell. As the seal swells, it slows the leakage. When the machine is able to be taken out of service, the seal should be replaced and the gearbox flushed to remove any traces of the seal compound that has been introduced. Filling the gearbox with grease is another simple solution that has been used success- fully. Grease has lower flow characteristics than oil and will not leak as fast. While grease will lubricate the gears effectively, more heat will be generated within the gearbox. Since grease does not dissipate heat as well as oil, the temperature should be monitored. All of these solutions are not true fixes but simple patches that can help until the gearbox can be taken out of service and properly repaired. Keep in mind that after adding anything to a component other than the appropriate lubricant, it should be removed and the interior surfaces flushed to eliminate all risks of incompatibility. All seals should also be replaced to reduce future leakage. 44 | September - October 2016 | www.machinerylubrication.com

Articles in this issue

Archives of this issue

view archives of Machinery Lubrication - Machinery Lubrication September October