Issue link: https://www.e-digitaleditions.com/i/1220484
kit I had, I used a 3" extension piece of BT- 20 and a 13mm–18mm centering ring that was sanded down to fit inside the coupler. Then a piece of 13mm (BT-5) tube with a standard BT-5–BT-20 centering ring on its forward end was then inserted into the coupler's modified centering ring. The shock cord was anchored to the forward end of the BT-5 stuffer tube by putting a large double knot in the end of the cord, sanding a groove on the in- side of the centering ring to accommodate the cord, then slipping the centering ring over it and gluing it in place (in my newer builds I've since replaced this section of the shock cord with steel fishing leader to as- sure durability). The rest of the setup then followed the same procedure of attaching the elastic/Kevlar/bungee cord combina- tion to the nose cone. It's important to note that the new pod section and attached hardware needs to be added to the aft end of the existing pod. In other words, trying to incorporate the pylon and hook as part of the new section won't give you good results. Trust me, I've tried it. If there are concerns about launch sta- bility from the added-on aft segment, you can either extend the pop pod's length or add some weight to the forward end. I chose the latter as it was the fastest and easiest to accomplish (and adding more length would still have added weight from the longer pod section and coupler any- way). To do this in my Condor example, I simply found the CG location on the stock pop pod before modifications and added clay to the front of the modified pod till it balanced in the same spot. It only required 3.35 grams (0.118 ounces), which is really not much. As you can see in Figure 5, there is only a marginal difference in overall length be- tween the original and modified pod (the original pod is at the top, the modified version is below it). It amounted to just +1.0" in overall length because I relocated the pylon/hook, cut the original tube, and added the necessary sliding portion to the aft end. If you have a large glider that uses 24mm motors, the correspondingly larger parts are quite readily available. Howev- er, I have some concerns about using the small, launch lug-sized Micro-Maxx BT-2 as a stuffer tube to retrofit a 13mm engine pod. My experimentation with it was in- conclusive and didn't prove that it's ad- equate in diameter to handle the ejection charge pressure. It's better not to retrofit in this case; just build a new 13mm–18mm rear-eject pop pod. So, if like me you're fed up with the frustration and disappointment of watch- ing your prized new glider or dependable veteran end its impressive and promising launch in a plummeting tangled mess of balsa and recovery gear, you now have a simple, effective alternative to finally defeat the Red Baron curse. 24 MARCH/APRIL 2020 SPORT ROCKETRY Minimum Diameter Retainer Tool-Free Threaded Motor Mounts » » » Quick-Change Motor Retainers, Tailcone Motor Retainers, Min-Diam Motor Retainers, Motor Adapters SS Ball Bearing Swivels, SS Recovery Hardware, 1010 & 1515 Low-Drag Rail Guides, High-Temp Epoxy 54mm to 3.9" Tailcone Retainer 75mm Flange Type Retainer 54mm Standard Retainer » phone: 858.566.2900 http://aeropack.net sales@aeropack.net Made in USA Some of the author's rear-eject pods that are swapped between gliders with the same pylon hook design.

