is the only point where sanding will occur
between the flat surface of the sanding de-
vice, and the curved surface of the cylinder.
Two problems are immediately obvious; 1)
effecting such a small contact surface will
SPORT ROCKETRY MARCH/APRIL 2020 33
Figure 17. On pad 2 ready for a Level 2 cert flight.
require an exceedingly long time to sand
the entire surface (refer to the reference
above where I die before that gets done), 2)
trying to sand a uniformly curved surface
using a flat sanding surface will never—re-
ally, never—conclude with satisfactory re-
sults. The very best effort to sand a cylin-
der with a flat block, will always result in a
compromise and not a true circle (and, no,
I am not going to debate the concept that
all circles are made of lines.)
With trumpets of victory loudly toot-
ing (we are in the garage after all) enter the
linear sander with custom sanding block
that exactly matches the shape of the sur-
face to be sanded. It works like this: Using
the custom sanding pad kit (Figure 10),
you stick the self-adhesive, red hook-n-
loop sheet to the rocket body and press on
a sandpaper sheet (Figure 11). Clip on the
big, hard-foam backing block to the sand-
er. Then, by running the sander, you sand
the shape of the tube into the block (Fig-
ure 12). The sander is sanding the shape
of the object (the body tube) into its own
backing block, rather than sanding down
Figure 18. Lift-Off! 4,575 ft. altitude,
587mph. Maybe Elmer would
have survived, maybe not.
And the rocket landed 20 ft. from
the pad (thanks to JLCR)!
C L E A N .
S I M P L E .
R E L I A B L E .
T H I N K I M P U L S E .
IMPLSLaunch . com