Sport Rocketry

Sport Rocketry 2.2020

Issue link: https://www.e-digitaleditions.com/i/1220484

Contents of this Issue

Navigation

Page 21 of 55

22 MARCH/APRIL 2020 SPORT ROCKETRY milliseconds by the pop pod itself. (Yes a slowed down video does show the pop pod and glider being thrown forward for an in- stant, but the momentum of the rearward moving engine pod yanks it free). At this point you may have already imagined ways to accomplish a rear-eject pop pod system, so I'll just share how I fabricated mine and tested it over the course of some 57 flights as of November 2019 (with not a single snagged glider in any of them). Let me also mention that this system is not meant for any compe- tition BGs where every fractional gram of weight saving is a priority. However if you value not DQing due to your recovery gear fouling your glider vs. a few extra grams of weight at launch, or if you're a sport flier like myself, then the following technique will be well worth an extra 20 minutes of your build time. In its simplest form it involves a tube momentum to ensure that it pulls the pop pod free of the glider. Note: I have not used this method with larger engines (with their correspondingly more energetic ejection charges) as most front-engine gliders will rarely employ anything larger than a D engine. As such my tests/prototypes were limited to the A through C engine classes. Attach a segment of flameproof elastic as a "bungee" setup connecting two points on the nose cone end of the Kevlar cord to absorb the shock (visible in Figure 1). This would still provide the needed amount of "yank" to pull the pod backward and off but with more positive and direct attach- ment than having only the section of elas- tic pull on the nose cone. This will relieve some of the initial violence of the ejection charge while still providing a positive con- nection once the elastic stretches and al- lows the cord to then pull directly on the nose cone. I found out the hard way that incorpo- rating elastic is a necessary thing to ame- liorate the often overly energetic force of the ejection charges incorporated into cur- rent motors. On its third test flight, the attachment loop on my plastic nose cone snapped. Luckily there was enough inertia to pull the pop pod free of the glider but it made me aware of how thin and frag- ile this loop can be on many lightweight plastic nose cones. Instead drill two small holes in the base of the nose cone and knot the shock cord through this, then lock it in with some epoxy. If you use a balsa nose cone, strengthen the base of the shoulder where the screw eye goes in with a gen- erous amount of CA or insert a hardwood Figure 2. Sliding piston motor mount. Figure 3. Retrofit pod configuration. nested within a tube, say an 18mm (BT- 20) motor pod inside a 24mm (BT-50) tube, or a 13mm (BT-5) inside an 18mm. Essentially it's an engine mount that serves as a sliding "piston," which is harnessed by a shock cord to a screw eye in the per- manently glued-in-place-nose cone (see Figure 1). I use at least 250# Kevlar. One improvement I've recently made is to use a length of braided steel fishing leader be- tween where it's anchored around the mo- tor pod and the Kevlar line. I've noticed that with many of my rockets, heat fatigue will cause the Kevlar cord to eventually burn through near where it's anchored around the forward centering. The steel leader will prevent that from happening since the steel is far more heat resistant. The exposed section of the Kevlar shock cord is limited to 12"-18" for A to C engine—more than that will cause the ejected motor and tube to lose too much

Articles in this issue

Archives of this issue

view archives of Sport Rocketry - Sport Rocketry 2.2020