Sport Rocketry

Sport Rocketry 2.2020

Issue link: https://www.e-digitaleditions.com/i/1220484

Contents of this Issue

Navigation

Page 32 of 55

is the only point where sanding will occur between the flat surface of the sanding de- vice, and the curved surface of the cylinder. Two problems are immediately obvious; 1) effecting such a small contact surface will SPORT ROCKETRY MARCH/APRIL 2020 33 Figure 17. On pad 2 ready for a Level 2 cert flight. require an exceedingly long time to sand the entire surface (refer to the reference above where I die before that gets done), 2) trying to sand a uniformly curved surface using a flat sanding surface will never—re- ally, never—conclude with satisfactory re- sults. The very best effort to sand a cylin- der with a flat block, will always result in a compromise and not a true circle (and, no, I am not going to debate the concept that all circles are made of lines.) With trumpets of victory loudly toot- ing (we are in the garage after all) enter the linear sander with custom sanding block that exactly matches the shape of the sur- face to be sanded. It works like this: Using the custom sanding pad kit (Figure 10), you stick the self-adhesive, red hook-n- loop sheet to the rocket body and press on a sandpaper sheet (Figure 11). Clip on the big, hard-foam backing block to the sand- er. Then, by running the sander, you sand the shape of the tube into the block (Fig- ure 12). The sander is sanding the shape of the object (the body tube) into its own backing block, rather than sanding down Figure 18. Lift-Off! 4,575 ft. altitude, 587mph. Maybe Elmer would have survived, maybe not. And the rocket landed 20 ft. from the pad (thanks to JLCR)! C L E A N . S I M P L E . R E L I A B L E . T H I N K I M P U L S E . IMPLSLaunch . com

Articles in this issue

Links on this page

Archives of this issue

view archives of Sport Rocketry - Sport Rocketry 2.2020