Sport Rocketry

Sport Rocketry 2.2020

Issue link: https://www.e-digitaleditions.com/i/1220484

Contents of this Issue

Navigation

Page 38 of 55

Figure 8. Relay module connected to six-channel receiver. Figure 9. Relay module, receiver (shown outside enclosure), 12V gel battery, and continuity circuits installed on 6-pad rack. be needed to adapt the DBR equipment for rocket motor ignition. Which brings us back to relays! Relay Modules A relay module is a prefabricated cir- cuit board that consists of one or more relays, connection terminals, and various electronic components used to support the relay functions, such as capacitors, diodes, resistors, timers, and memory de- vices. Many of these support components are not necessary for model rocket ignition systems. The first receivers that I adapted were single-channel types that operated on four AA batteries. I put together pad boxes that contained homemade relay modules that consisted of a small breadboard, a 6V relay (the rated relay voltage refers to the coil, not the load), a 12V (eight AA) battery pack and a pushbutton-operated buzzer for continuity check (Figures 4, 5, and 6). Instead of terminal blocks I just sol- dered lead wires to the relay pins. I did all this because (a) it was cheap, maybe $3 per board, and (b) it didn't occur to me to Google "relay modules" (D'oh, Hom- er!). But it took some time to assemble the boards and as my soldering skills are not exactly stellar (often interrupted by inju- ries/expletives), I began looking for better alternatives. Performing a Google search for "9V re- lay module" yielded a whole new world of electronics enlightenment, with dozens of components of various types popping up. I eventually settled on a "6-channel 10-Amp Driver Board with DIN Rail Mount" (Fig- ure 7) obtained from AliBaba for $18.80 and Free Shipping! The module has screw-type terminal blocks for input and output, which made for easy, solder-free (yay!) connections. The leads from the receiver connect to the input side; connect the +12V battery lead to the "Common" (COM) output terminal, and connect one of the igniter leads to the normally-open (NO) output terminal and it's good to go! The one thing the relay modules do not provide is a continuity check circuit. This is easily remedied by connecting a simple external buzzer-and-pushbutton circuit across the COM and NO terminals. SPORT ROCKETRY MARCH/APRIL 2020 39

Articles in this issue

Archives of this issue

view archives of Sport Rocketry - Sport Rocketry 2.2020