Sport Rocketry

Sport Rocketry 2.2020

Issue link: https://www.e-digitaleditions.com/i/1220484

Contents of this Issue

Navigation

Page 42 of 55

boards that use the small handheld-type remotes, which are not expandable/mod- ular and don't have safety switches. Some hacking would be in order to make a suit- able firing panel and receiver box. Modules are available with latching and time-delay functions, so there is a lot of development potential (Figure 24). Interference and Durability Issues One concern that is often expressed is the potential for interference from other wireless sources. The fireworks control- lers all have built-in circuitry to lock out interference that might cause an inadver- tent ignition. Our club has used the DBR and MSQ12 for over three years and not ing stations, which caused a loss of range. Shutting off the transmitter for a minute or so cleared it up. Another concern is the durability of the wireless components, specifically the DBR receivers, which are not weatherproof. In- stalling the receivers in weathertight enclo- sures is the solution. FSA's MS12Q receiver recently malfunctioned; some of the cues are no longer working. It may have been exposed to moisture or contamination, or there may be some other cause. We will eventually replace the unit, but as it was already relegated to a backup role after the Cobra was acquired there's no pressing ur- gency. The DBR receivers have fragile anten- nas (a few of which have broken off, with no noticeable loss of range) and the battery terminals inside a couple of the receivers have rusted a bit, all of which is a direct result of rough use, Florida humidity, and having been stored in a crappy shed. But overall the systems have held up well, cer- tainly no worse for wear than many hard- wired systems. Retrofitting Hard-Wired Relay Systems If a club already has a hard-wired sys- tem, it can probably be converted to an op- tional wireless operation fairly simply. All that would be required is to connect leads from the wireless receiver terminals to the existing relay input connections. It might take some fussing around in tight spaces, and may not prove practical depending on the type of relay installation methods but the operating principle of activating relay coils is the same. SPORT ROCKETRY MARCH/APRIL 2020 43 once has a rocket ever gone off unexpect- edly as a result of interference (operator error, yes). The only interference problem our club has experienced was apparently from nearby landfill wireless monitor- TO FIND FELLOW TO FIND FELLOW MODEL ROCKETEERS MODEL ROCKETEERS NEAR YOU, VISIT: NEAR YOU, VISIT: WWW.NAR.ORG WWW.NAR.ORG CLICK ON: CLICK ON: "FIND A LOCAL CLUB FIND A LOCAL CLUB" Figure 22. Mid-power rocket range with igniter leads extending from range box (oval).

Articles in this issue

Links on this page

Archives of this issue

view archives of Sport Rocketry - Sport Rocketry 2.2020