vid applied a chamfer to all the edges and
holes, which means putting a small bevel
on all the corners and edges, so they would
not be sharp.
David sandblasted the bulkheads (see
Figure 6, of a previous design) and then
painted the bulkheads with high-tempera-
ture paint (see Figure 7, also of a previous
design). I came up with an excellent mne-
monic for bulkhead color: red is down for
motors, and blue is up for the sky. How-
38 SEPTEMBER/OCTOBER 2020 SPORT ROCKETRY
ever, when I made my machining specifi-
cation, I mistakenly got them switched in
my instructions. They came out backward,
of course. The moral is that when you out-
source fabrication, the parts come back as
per your spec, even if your requirements
are wrong. The pieces do not fix them-
selves, so a meticulous review of design is
paramount. Since the parts are expensive, I
decided not to redo them or have them re-
painted. I guess that I will have to come up
Figure 4b. 3D rendering of the
drogue bulkhead.
Image by David Figger.
Figure 4c. The assembled drogue bulkhead. This figure also shows
the altimeter sled, which nests in the rounded edge of the body tube.
www.BalsaMachining.com
$5.95 in bulk pack format