Sport Rocketry

Sport Rocketry 5.2020

Issue link: https://www.e-digitaleditions.com/i/1283117

Contents of this Issue

Navigation

Page 39 of 55

(Figure 13) • RocketJunkies machined wire feedthrough on both ends • RocketJunkies charge cups (Figure 4c) • RocketJunkies custom bulkhead • AltusMetrum Telemetrum transmitter/triple backup altim- eter Eggtimer Tx transmitter for tracking (Figure 10, top right) • Two or three LiPo batteries in 3D printed battery box holder (depending on configuration) • 3D printed sled with a rounded edge to lay on the outside edge of altimeter compartment (Figure 4c) • 3D printed guillotine clamp to keep the D-ring from knocking into = assembly (Figure 1) 40 SEPTEMBER/OCTOBER 2020 SPORT ROCKETRY Figure 6. Bulkheads after sandblasting (these bulkheads are from an earlier design). Photo by David Fliger. Figure 7. Machined and painted bulkheads (these bulkheads are from an earlier design). Figure 8. Unassembled mechanical parts. Figure 7. Figure 6.

Articles in this issue

Archives of this issue

view archives of Sport Rocketry - Sport Rocketry 5.2020