Sport Rocketry

Sport Rocketry 6.2020

Issue link: https://www.e-digitaleditions.com/i/1302769

Contents of this Issue

Navigation

Page 13 of 47

A Tale of Two Altitude Models by Chris Flanigan Last year, I built and flew a 1/2A Alti- tude model for NRC. It was a pretty basic (quick, low-effort) model. On a 1/2A3-4T and 34" piston, it had a good but not great flight of 182 meters. Based on some conversations with Steve Kristal and Trip Barber at NARCON, it appeared that good surface finish was very important, even for a moderately low velocity model like 1/2A altitude. For Vir- tual NARAM, I built a new 1/2A Altitude model (see Figure 1). Differences between the new vs. old model: • The new model has a smooth surface finish (sanded body tube, then one coat of primer, sanded smooth using 320 and 400 grit sandpaper). The old model was just standard white BT-5 body tube. • The new model uses vacuum-formed plastic nose cone from Apogee. The old model used a somewhat short 3D printed nose cone. • The new model was ~1" shorter, had smaller fins, and was ~1 gram lighter (5.3 grams vs. 6.5 grams, without 14 NOVEMBER/DECEMBER 2020 SPORT ROCKETRY motor or altimeter) compared to the old model. I flew the new model for Virtual NARAM. Results of the new model were noticeably better than the prior model (see Figure 2). Using the as-shown data (ex- cluding temperature corrections), the new model went ~48 m (158 ft) higher than the old model. OpenRocket predicted a dif- ference of 170 ft – very close! Most of the improvement was related to better surface finish, but some improvement came from lower mass and less wetted surface area. Bottom line: improved surface finish and better design do make a difference for altitude models. Figure 1. Figure 2.

Articles in this issue

Archives of this issue

view archives of Sport Rocketry - Sport Rocketry 6.2020