Sport Rocketry

Sport Rocketry 6.2020

Issue link: https://www.e-digitaleditions.com/i/1302769

Contents of this Issue

Navigation

Page 41 of 47

42 NOVEMBER/DECEMBER 2020 SPORT ROCKETRY fabricated from metallized polyethylene poncho material. The preparation seques- nce is shown in the photos. First, I folded the parachute onto itself, then into succes- sively thinner "V" shapes by folding it in half lengthwise several times until it was just under twice the width of the spool. Then I laid the shroud lines up to the point of the parachute and back down to the spool. The final step was to fold the para- chute the final time lengthwise and to roll it onto the spool using the wide ribbon to hold it in place. Having contained the parachute, I wrapped the delay streamer first around the center area of the spool, and then even- ly around the entire width of the spool. The parachute compressed nicely, and there was plenty of room on the spool to allow a longer delay streamer to be used if a longer delay was desired. The rocket was prepped by inserting eight crumpled squares of Estes recovery wadding five inches down the tube, and then the Chute Spool was inserted. There is a small piece of foam between the top of the spool and the nose cone to keep would allow plenty of time for the delayed parachute deployment. This would be the first time I had ever launched a rocket in my own yard with a C engine total impulse. I was counting on the delayed parachute release to keep the rocket near the launch site and away from a number of large trees and a pond next door. (The wind direction appeared vari- able, so even though it was calm, it was a guess which way the rocket would drift). The test rocket used an 18" parachute www.BalsaMachining.com $5.95 in bulk pack format Electronic Deployment Only $15 (Basic kit, and with optional Easy Mount) The Eggtimer Apogee Pops your parachute out at apogee, and beeps out your altitude afterwards… no programming required! Say goodbye to the "How much should I drill out the delay?" guessing game. Ideal companion for the Jolly Logic Chute Release™… it does for you what the JLCR can't. Built-in screw switch and JST-PH battery connector Only 1.75" x .9", fits in a 24mm engine mount tube Reports to 60,000', fully mach-immune Easy to build kit… almost all through-hole parts, illustrated step-by-step instructions. Eggtimer Rocketry info@eggtimerrocketry.com Visit us at EggtimerRocketry.com, and see our full line of rocketry kits… deployment altimeters, GPS/RF trackers, and wireless switches. Parachute folded long and narrow. Ready to roll.

Articles in this issue

Links on this page

Archives of this issue

view archives of Sport Rocketry - Sport Rocketry 6.2020