Sport Rocketry

Sport Rocketry 2.2021

Issue link: https://www.e-digitaleditions.com/i/1345417

Contents of this Issue

Navigation

Page 22 of 47

use a long coupler, a centering ring, and a body tube to help align it with the main body tube (Figure 3). These will slide out easily after the glue on the two aft rings dry. For the transition, use a tube cutting guide to evenly slide it up the tube and into the glue (Figure 4). The completed payload section shroud is shown in Figure 5. Both rockets use half-moon type baf- fles built inside their tube couplers. For the 60, the shock cord tethering harness is an- chored here. Since the 70's upper tube is 11" long, I put in a parachute shelf with a harness about 4 or 5 inches down from its forward end (Figure 6). The fins for both rockets use 3/32 balsa. The 60 uses 4 fins offset 45 degrees from the SRBs. The 70 uses 6 fins, two of which will run through the SRBs. I did this on an earlier SLS build and I really like the SPORT ROCKETRY MARCH/APRIL 2021 23 Rocket Motors, Kits, & Accessories Rocket Motors, Kits, & Accessories Delivered to Your Doorstep Delivered to Your Doorstep Rocket Motors, Kits, & Accessories Rocket Motors, Kits, & Accessories Delivered to Your Doorstep Delivered to Your Doorstep ✔ Same/Next Day Shipping ✔ Real Time Inventory ✔ Order Confirmation ✔ Order Tracking ✔ No Memberships ✔ Shipping to Alaska please inquire We carry Aerotech motors & kits, LOC Precision kits, Jolly Logic electronics, and adhesives! Figure 3 (Above). Preparing to glue on the payload section tube and transition. Figure 4 (Left). Using an Estes tube cutting guide to slide the transition shroud evenly into place. Figure 5 (Below). The completed payload section tube and shroud.

Articles in this issue

Links on this page

Archives of this issue

view archives of Sport Rocketry - Sport Rocketry 2.2021