use a long coupler, a centering ring, and a
body tube to help align it with the main
body tube (Figure 3). These will slide out
easily after the glue on the two aft rings dry.
For the transition, use a tube cutting guide
to evenly slide it up the tube and into the
glue (Figure 4). The completed payload
section shroud is shown in Figure 5.
Both rockets use half-moon type baf-
fles built inside their tube couplers. For the
60, the shock cord tethering harness is an-
chored here. Since the 70's upper tube is
11" long, I put in a parachute shelf with a
harness about 4 or 5 inches down from its
forward end (Figure 6).
The fins for both rockets use 3/32
balsa. The 60 uses 4 fins offset 45 degrees
from the SRBs. The 70 uses 6 fins, two of
which will run through the SRBs. I did this
on an earlier SLS build and I really like the
SPORT ROCKETRY MARCH/APRIL 2021 23
Rocket Motors, Kits, & Accessories Rocket Motors, Kits, & Accessories
Delivered to Your Doorstep Delivered to Your Doorstep
Rocket Motors, Kits, & Accessories Rocket Motors, Kits, & Accessories
Delivered to Your Doorstep Delivered to Your Doorstep
✔ Same/Next Day Shipping
✔ Real Time Inventory
✔ Order Confirmation
✔ Order Tracking
✔ No Memberships
✔ Shipping to Alaska
please inquire
We carry Aerotech motors & kits, LOC Precision kits,
Jolly Logic electronics, and adhesives!
Figure 3 (Above). Preparing to glue on the payload
section tube and transition.
Figure 4 (Left). Using an Estes tube cutting guide
to slide the transition shroud evenly into place.
Figure 5 (Below). The completed payload
section tube and shroud.