SPORT ROCKETRY MARCH/APRIL 2021 31
critical to producing parts that are impact-
resistant. Parts must be post-cured under
ultraviolet light of the correct wavelength,
but can be overcooked to the point of be-
coming very brittle.
With experience I eventually conclud-
ed that my concern regarding the strength
of 3D printed parts was unfounded (al-
though that won't be true of all 3D print-
ing resin or filament materials and I'm not
pursuing Mach-busting attempts), but I
still make regular use of the epoxy resins
and structural foams to add noseweight or
sometimes reinforce key structural parts.
Notably, the most impact-resistant resin
I've tried (iFun ABS-Like Resin) is more
than twice as expensive as some of the
standard resins I've worked with, so I still
use the epoxy resin as a cost-effective rein-
forcement with cheaper resins and still end
up with a stronger part than the best 3D
printing resin alone.
If I'm making a large nose cone and
don't want to completely fill it with resin
(the last 4-inch cone I made would have need 2.5 liters to
fill) I'll use something like a soda bottle or similar in the inte-
rior of the part to take up some of the volume and pour the
casting resin around the outside of it (more "found" parts…).
Structural two-part expansion foam (needs to be the high-ish
density structural variety) can also be used to reinforce hol-
Figure 4.
Figure 5.
North Coast Rocketry
www.NorthCoastRocketry.com
Advanced Rockets that are
easy to build, fun to fly and
look great!
Setting the
standard since
1984!
SA-14 Archer Lance Delta Cluster Duck