Issue link: https://www.e-digitaleditions.com/i/1408247
ration, a small charge generates a substan- tial amount of pressure in the small volume that shears the Nylon bolt allowing the two pieces to separate. Once the piston moves 1/4 of an inch, the pressure dissipates. The result is that the strap-on booster gently moves away. The strap-on boosters are deployed in pairs near the end of their motor burn, but the three sets are sequenced with a 0.2 sec- ond delay between them. The cameras in the first strap-on boosters to be deployed are looking upward while the last pair look downward. Each pair has its own timer along with the current limited circuitry to ensure each charge is fired at the same time. In order to capture this event, some very creative camera payloads were need- There are two reasons why there are so many cameras. The first is that each has a different function. Some are shooting vid- eo, others stills. They have different lenses for different perspectives, and others have unique functions. One camera is mounted in the transition looking forward and its sole purpose is to film the main parachute deployment. Secondly, there is a certain amount of redundancy in case a camera fails to record. Throughout this project 3D printing technology is utilized. Some printed parts are directly used on the rocket like the nose cones for the strap on boosters, the cam- era fairings, the transition, etc. while other pieces are printed and then used to make molds to fabricate the parts to be used on the rocket. This later technique was used exten- sively on the strap-on boosters. The booster droppers, the shrouds that surround them and glue them on the boosters, and even the bell shaped motor retainer are all molded pieces. This is necessary since these parts are subjected to very high temperatures, so they needed to be molded from JB Weld. Af- ter pieces were printed and smoothed with primer paint, a silicone mold was made from the 3D part. Then parts for the rocket could be made from the silicone mold using JB Weld. The final part used on the rock- et can withstand the high pressure of the charges going off and the excessive temper- ature of the motor during its burn. The precision of the 3D printers was necessary in key aspects of the project. Use of 3D printing for mounting of the strap- on boosters on the rocket's main body was a tremendous asset since the alignment around the rocket could be precisely print- ed. Precision of the 3D printer also allowed 26 SEPTEMBER/OCTOBER 2021 SPORT ROCKETRY FOR ALL YOUR MOTOR NEEDS www.BALSAMACHINING.com We carry the complete Estes, Quest & Aerotech motor lines. Go to our website and see how you can save 25% OFF high power propellant and 20% OFF high power hardware using our pre-order program. Ejection at about 11,000 ft. apogee. ed on board as well. There are two Sony RX0 II cameras that are an excellent choice for a rocket. With their 1" sensor, anti- distortion shutter that virtually eliminates rolling shutter affect, and a burst mode and adequate buffer size they can capture the flight in clear, crisp images. Two are used in the payload section, one for video and the other for still images. In addition, there is the very powerful Chronos 1.4 high-speed camera that records over a thousand frames per second at nearly 1080P resolution. Its recording time is limited to the strap-on booster separation and apogee but at nearly 40 times slow motion, incredible details are revealed. There are also a number of Sony Action cameras on board that shoot both video and still images.

