Issue link: https://www.e-digitaleditions.com/i/1408247
the cameras to be mounted with precise angles. I wrote an article over 20 years ago about mounting of large cameras in a rocket that required a mirror to look down the length of a rocket. I demonstrated mathematically that by angling the camera upward in the rockets body, the size of the mirror can be greatly reduced. This technique was used for the Chronos camera in Final Cut. It is very large camera with a large sensor so it is natural the mirror is also large. Without this technique it would not have been practical to mount such a camera in a rocket this size. Standard composite construction tech- niques were used to make the fins. The ply- wood core is two pieces of ¼" thick, twelve- layer plywood that is laminated together. After sanding the fins to shape, the edges were routered to make them round. Then two layers of carbon fiber fabric were vacu- um bagged on the fins for strength and ri- gidity. For both the plywood layup and the vacuuming bagging, the pieces were cured between to slabs of granite surface plates. This ensures the fins are very flat to reduce roll. The slabs were heated for post curing of the epoxy. My fascination for photography doesn't just apply to rockets that I build. I also use multiple cameras on my launch pad to re- cord events on the ground in addition to liftoff. My entire launch pad set up had photography in mind. The launch pad was literally designed for cameras to be mount- ed in a way that uniquely records the rocket during taking off. There can be cameras at the top of the tower to look down the rail during liftoff. Cameras can be mounted to the base for close up of the motor ignition, and there is even an arm at the top of the rail to support additional cameras. The pentagon shaped pad has five legs that are angled outward for a very large base for extra stability; a radio tower section that is hinged to the base with a counter weight that greatly aids in raising the tower. Guy wires secure the tower section to the base and the entire launch pad is staked into the ground to prevent tip overs. Of course this means you cannot adjust the azimuth once the pad is in place but that is usually not a problem. There are several camera mounts lo- cated on tripods that surround the launch pad. Most cameras take video but a few also shoot still images as well. Cameras in each mount use different lenses and are located at different distances from the rocket to cre- ate a different perspective of the rocket. The most distinctive feature of the launch pad set up is a telescoping pole that supports several cameras 35 feet off the ground. Although comparable to a drone shot, any type of camera and/or lens can be mounted on the pole. Typically, there are five different cameras mounted on the pole including another Chronos high-speed camera used to record liftoff in super slow motion. This provides unique footage that no drone could duplicate. Many of the camera mounts for the setup are built to pitch upwards and follow the rocket after liftoff. I designed and built a camera controller that is used to control all actions including: starting all the cam- eras, lighting the igniters for the motors, detecting the rocket liftoff for tracking, and stopping the recording, all automati- 28 SEPTEMBER/OCTOBER 2021 SPORT ROCKETRY View of irrigation circles in the San Luis Valley, taken from a camera on one of the separated side boosters. Rocket Motors, Kits, & Accessories Rocket Motors, Kits, & Accessories Delivered to Your Doorstep Delivered to Your Doorstep Rocket Motors, Kits, & Accessories Rocket Motors, Kits, & Accessories Delivered to Your Doorstep Delivered to Your Doorstep ✔ Same/Next Day Shipping ✔ Real Time Inventory ✔ Order Confirmation ✔ Order Tracking ✔ No Memberships ✔ Shipping to Alaska please inquire We carry Aerotech motors & kits, LOC Precision kits, Jolly Logic electronics, and adhesives!

