ered segment 1. Above that, low end slits
are cut into the bottom of the stacked seg-
ments 2, 3 and 4.
With the tube slits folded in and the
glue dried, you will be sliding the three up-
per segments together, dry with no glue.
e slits in segments 2 and 4 are in line
with each other. e slit in segment 3 is di-
rectly on the opposite side.
Notice in the side profile drawing how
42 MAY/JUNE 2022 SPORT ROCKETRY
Nose cone shoulder.
NARTS ONLINE:
https://blastzone.org/nar/narts/
T-Shirts
White T-shirt, 100% cotton, 4 colors,
NAR logo front chest. Sizes S-XXXL.
Sun Block Hat
After two years of back
order, we have finally
found a supplier for
the "Desert Hat".
ONLY
$
27
00
• mesh liner designed to
promote cooling and
minimize staining.
• adjustable tie for
just-right fit
• terry cloth sweatband
• hidden zipper
Blast Deflector
Replace that worn-out deflector plate with a Heavy
Duty Blast Defector 5" diameter, 12 guage steel.
ONLY
$
5
00
Jacket Patch
Embroidered patch of the NAR logo.
Just the item for jackets, hats, or
anywhere else you want
to show off your hobby!
ONLY
$
4
00
ONLY
$
16-21
00
Embroidered black, white, and gold
triangular patch for those inclined
towards frequent "close encounters!"
ONLY
$
4
00
Forming the nose cone.
the segments are angled, the inside ends of
the segments are close to touching the in-
terior tube. Make adjustments to the angles
as you assemble the segments. Apply a bit
of glue to the outside joints, enough to hold
it together for now and allow adjustments
to the assembled stack.
Glue the upper centering ring into the
top of segment 4, recessed in about 1/4",
just like the bottom centering ring.
