Inhalation

INH1026

Issue link: https://www.e-digitaleditions.com/i/1546950

Contents of this Issue

Navigation

Page 14 of 43

Inhalation OctOber 2026 13 CFPD simulations showed the use of add-ons altered the amount of drug depositing in the upper airways. However, the extent of this reduction varied across designs and some add-ons increased upper-airway fil- tration efficiency. Moreover, add-on performance was specific to both the inhaler model and the applied flow rate. Based on the CFPD results, two geome- tries demonstrated consistently favorable behavior: (1) a gradually diverging conical shape with a 5° cone angle, expanding the inhaler-specific outlet cross- section to one with a surface area comparable to that of a pressurized metered dose inhaler (pMDI) mouth- piece; and (2) a cup-like geometry that increased the cross-section sharply at the entrance before gradually narrowing to a final size similar to that of the conical design. e conical shape primarily promoted flow laminarization, whereas the cup-like shape created a buffer region that facilitated the dissipation of jets emerging from the DPI outlets. upper-airway particle-deposition fractions. To illus- trate this, Figure 3 shows the complicated velocity vector fields of the air near the mouthpiece of the Turbuhaler (upper right) and the Ellipta DPIs (lower left) and the less perturbed fields in the inhalation channel and outlet of the Breezhaler (upper left) and the NEXaler DPIs (lower right) at a 30 L/min inha- lation flow rate. e figure refers to flow fields with- out add-ons for all four devices. e velocity vector fields of the Turbuhaler and Ellipta are more turbu- lent because of their internal geometries. e swirl- ing channel inside the Turbuhaler and the split flow rejoining near the outlet of the Ellipta cause highly perturbed flows, which have no possibility to atten- uate before leaving the mouthpiece. On the other hand, the airflow is modulated by straight channels before leaving the Breezhaler and the NEXaler. e differences among the near-mouthpiece flow characteristics predict different possibilities for air- flow and particle trajectory modulation. Figure 3 Vector fields near the inhaler exit for the Breezhaler ® , Turbuhaler ® , Ellipta ® and NEXThaler ® DPIs at a 30 L/min inhalation flow rate Breezhaler® Turbuhaler® Aerosolizer grid Ellipta® NEXThaler® Outlet Outlet Outlet Inlet vent Cyclon chamber Outlet

Articles in this issue

view archives of Inhalation - INH1026