Machinery Lubrication

Machinery Lubrication May June 2014

Machinery Lubrication magazine published by Noria Corporation

Issue link: https://www.e-digitaleditions.com/i/325287

Contents of this Issue

Navigation

Page 27 of 77

www.machinerylubrication.com | May - June 2014 23 CuttiNG FLuiD QualiChem's Xtreme Cut 292 metalworking fluid is specifically designed to overcome the challenges of working with difficult alloys such as titanium, Inconel and stainless steel. The new lubrication technology incorporated into the fluid can eliminate foaming, staining and res- idues while offering better lubricity than traditional heavy-duty soluble oils. Formulated with the safest metalworking chemistries, the water-based fluid has a low-toxicity profile and is safe for end users and the environment. QualiChem www.qualichem.com 540-375-6700 autOMatiC LubriCatOr The new Simalube 15-milliliter automatic lubricator from Simatec is intended for lubrication points that require only a small amount of lubrication. It provides a minimal but continual amount of lubrication (grease or oil) during a desired time setting (one to 12 months). With a slim aluminum housing, the lubricator can be installed in tight spaces and incorporates a closed system that inhibits the penetration of dirt. It is especially suitable for linear guides, electric motors, pumps, ball screws and small bearings. Simatec www.simatec.com 704-588-3320 hiGh-teCh OiLs aND Greases The Tec-Flon family of non-hydrocarbon, non-silicone, fluo- rinated oils and greases was created specifically for use with plastics, in paint shops where silicones are not permitted or in vacuum environments. The high-tech lubricant materials remain effective when used for high-performance applica- tions and even in high-temperature settings. They also meet or exceed the performance requirements of General Motors and are well-suited for use in electronics, optics, aerospace, cleanrooms and general assembly applications. Solid Technical Solutions www.tectorius.com 586-232-3999 VarNish reMOVaL FLuiD Fluitec's Boost Varnish Removal (VR) fluid was developed to provide a safer way of removing varnish and sludge from turbine and com- pressor oil systems. The fluid cleans the internals of the system while the equipment is operating and does not require the use of a sacrificial rinsing fluid. Unlike conventional cleaners, Boost VR can safely be used in steam and hydro-electric turbines as well as other applications where there is a high chance of water or steam ingression. It is also compatible with mineral oils and some synthetics. Fluitec www.fluitec.com 201-946-4584

Articles in this issue

Links on this page

Archives of this issue

view archives of Machinery Lubrication - Machinery Lubrication May June 2014