42 MAY/JUNE 2017 SPORT ROCKETRY
RumbleBee-C Parts List
1 6" x 30" x 3/32" balsa sheet (from Sig) SIGB159 wing
1 10" x 3" x 1/16" C-grain balsa sheet SIGB478 stab/rudder
1 17.55" x 1/4" x 1/8" basswood SIGBA014 fuselage
1 2" x 1/8" x 1/8" basswood SIGBA012 radio pod pylon
1 2.75" x 1" x 1/8" balsa SIGB137 pylon
1 2" x 5/8" x 1/32" plywood SIGPW001 radio plate
1 1/32" dia. music wire SIGMW001 linkages
1 radio pod nose cone ACNC20 AC Supply
1 motor pod nose cone ACNC50 "
1 2" long radio tube ACBT20 "
1 2.75" long motor pod tube ACBT50 "
1 2.25" long motor module tube ACBT20 "
2 adapter rings for motor module ACCR2050 "
1 3/16" launch lug ACCL200 "
1 radio system Turnigy 5X set 9331000002-0 Hobby King
1 servo HK linear HK3D-1.7L "
1 battery, 3.7V Turnigy lithium cell N160.1S.25 "
1 battery cable (from charging cable) PICMX6 "
1 1.8mm dia. x 11" carbon fiber pushrod CF9 carbon rod "
1 control horn 007-00301X10 "
1 charger E-Flite USB EFLC1008
1 streamer 1.75" x 14" orange plastic
Stabilizer/Rudder
Cut the stabilizer and rudder out of
1/16" balsa using the templates. Use a new
X-acto blade for nice, clean cuts. Sand the
edges rounded (but not the base of rud-
der). Cut off the 3/4" rudder tab. Space
the rudder tab with an 1/8" gap, and apply
a scotch tape hinge. In the gap, push the
tapes on either side together. CA the horn
on the left side of tab (see the drawing).
Full size templates.
