Machinery Lubrication

Machinery Lubrication September-October 2019

Machinery Lubrication magazine published by Noria Corporation

Issue link: https://www.e-digitaleditions.com/i/1171112

Contents of this Issue

Navigation

Page 15 of 70

ML www . machinerylubrication.com | September - October 2019 | 11 The "used oil" storage and buckets are kept far from the new oil storage. Retained & Filtered Oil Retained & Filtered Oil Changed Oil Changed Oil 2017 2018 The percentage of retained and fi ltered oil to changed oil for 2017 and 2018 6. Keep the tops of oil drums in the oil storage shed free and clear of any and all foreign debris. Ensure the drums are clean before and after extracting oil from them. e equipment installed had a tremendous impact on preventing and reducing contamination. e drain and breather mounts have allowed Advanced Composites to engage in better fi ltering and sampling practices. Before, the facility was only fi ltering during shutdowns or changeovers. Personnel would have to install and connect to plugs and pipes, and fi ltering was performed on cold, uncirculated oil. Usually, the pipes and plugs were not wiped down, which would lead to more contam- ination entering the system. Now, they are able to complete in-service fi ltering while the equipment is making product. Most importantly, the oil is warm and agitated, so the fi ltration is better. e team has also installed desiccant breathers on their machines for moisture and particle prevention. Currently, Briner is looking to fi ne-tune the time required for the equipment's quarterly oil fi ltering. is could potentially save man hours and workable fi lter cart conditions. In addition to fi ltration, the drain and breather mounts have improved sampling practices. Previously, personnel had to open the system to the dusty environment to obtain a sample at the breather port. Now, they can collect an oil sample without opening the system to the outside environment. e sample is pulled directly into the bottle while the equipment is in full operation, providing a better representation of the oil's condition. Doing everything they can to minimize contamination during the sampling process ensures the results are reliable. CARBON FOOTPRINT One of Advanced Composites' goals as an organization is to reduce its carbon footprint. Within the lubrication program, the company strives to minimize oil waste by educating the PM task team on how to prevent oil contamination. is starts with properly fi lling equipment with new oil and continues through oil sampling and daily visual inspections of all seals and oil levels. Back when Advanced Composites was performing semi-annual oil changes, it was leaving a big carbon footprint in terms of its disposed oil. As mentioned previously, the facility was disposing of 916 gallons of oil per year and spending an average of $11,475 annually on just 12 pieces of equipment. rough improved understanding of oil analysis results, better sampling and fi ltering, and contamination reduction strategies, unnecessary oil changes were eliminated. From 2013-2016, the company focused on putting all the necessary blocks in place so it could start gathering and reporting numbers. One of the biggest changes was to the work environment. e team had to be educated on the importance of providing these numbers, which could then be reported to upper management, allowing them to see the improvements being made. In 2017, 28 pieces of vital equipment were being maintained. By fi ltering 1,856 gallons of oil, the site retained 1,293 gallons in the machines and only had to change out 563 gallons. In 2018, 25 pieces of vital equip- ment were proactively maintained with the drain and breather mounts installed. e facility fi ltered 1,510 gallons of oil, retaining 1,350 gallons and changing out 160 gallons. 30% 30% 70% 70% 89% 11%

Articles in this issue

Links on this page

Archives of this issue

view archives of Machinery Lubrication - Machinery Lubrication September-October 2019