Issue link: https://www.e-digitaleditions.com/i/1184256
B Egg Lofting Duration by Buzz Nau B Egg Lofting Duration was com- plete with its typical share of no deploy- ments, models lost to thermals, and shat- tered eggs. Of the 85 official flights, 36% were not qualified. Weather was not to be blamed as it was sunny with some ther- mals and winds were under 10 mph from the west. Most entries followed the shroud body design with egg capsules that includ- ed vacu-formed CMR type, plastic Easter eggs, and balloons. In A Division, Ryan Stenberg's strategy was to start with a conservative qualified flight. With that completed, he hoped to exceed his first flight with his "go for it" egglofter that used a 48" chute. The only problem was it performed too well and thermalled away after seven minutes. For- tunately, his first flight duration held, nar- rowly exceeding Madalynn Pund's best flight by two seconds for first place. Becky Zurek's approach in B Division centered on 3D printing using a single wall thickness ABS-plastic body and balloon 18 NOVEMBER/DECEMBER 2019 SPORT ROCKETRY B Egg Lofting Duration A Division Time (sec) 1 Stenberg, Ryan* 48 2 Pund, Madalynn* 46 3 Tactical Warheads 39 B Division 1 Zurek, Rebecca* 30 2 Acevedo, Xandria 12 3 Emmanuel, Destinee 11 C Division 1 Ring, Chad* 181 2 Dall, Betty 147 3 White, Terry 82 D Division 1 Flying I-Beam Kids* 277 2 Escape Velocity* 125 3 Neutron Fusion* 77 * Denotes ESA qualified The H-Bomb team loads their balloon-capsuled egglofter into the tower. Chris Flanigan shows off his B Egg Lofting Duration model. It is scratch built out of 60# cardstock.

