Issue link: https://www.e-digitaleditions.com/i/1184256
SPORT ROCKETRY NOVEMBER/DECEMBER 2019 45 use one fixed base station and one rover, utilizing data from four satellites. The rocket will carry the device that is the rov- er. GNSS and RTK can be accurate to with- in 1 or 2 cm, so the idea is not far-fetched. The biggest technical barriers are (1) cur- rent GNSS hardware doesn't allow for a way to transmit the error correction data to the rover in the rocket; (2) the acceleration levels of rockets may be too fast for today's GNSS receivers to recover by apogee; and (3) the base station needs to be within 10 km of the rockets. Whether the future will allow these barriers to be overcome is un- known, but Dan certainly provided us with a fascinating assessment of this topic. Chris Flanigan is a frequent R&D winner, and this year's report once again showed his fastidious attention to de- tail with his simulation and testing of rail launchers. Chris's study highlighted the importance of where the rail lugs or but- tons are placed on the rocket. Angle of the rocket and launcher with respect to wind direction can affect how smoothly the rocket travels on the rail. Too much sepa- ration between upper and lower rail lugs can lead to excess friction or buckling on the rail. The Neutron Fusion Team considered a new idea for fitting a rocket to a piston launcher using a pair of neodymium ring magnets, one secured to the bottom of the rocket motor and atop the piston tube. The team found that the magnetically fit pis- tons worked very well with black powder motors and may provide more consistent performance, reducing some of the subjec- tivity of an ideal fit. But the most promis- ing future use might be in piston-launch- ing with composite motors. Quickly Locate Your Downed Rocket in MINUTES! Powerful Tracking Transmitters 2-9 Mile Ground Tracking Range/10+ Mile Air Tracking Range Lightweight Transmitters 2 Grams & up Waterproof Circuits Durable and Easily Transferred from Rocket to Rocket Telemetry Specialists Since 1970 Receiver Models Tracking from 3 to 200 Rockets Formerly Walston Retrieval TRACK YOUR ROCKET FROM LIFT OFF TO LANDING! 1202 Walnut Street Murphysboro, IL 62966 800-842-4537 Toll Free www.wmimodelaeronautics.com 618-687-3505 Fax: 618-687-3539 Email: mikec@caretrak.com Don Carson explored the use of tor- sion springs for the flop-wing mechanisms on some types of boost gliders. Don found through experimentation the best thick- ness of music wire, eventually arriving at a very effective and reliable mechanism. Re- becca Zurek studied parachute spill holes, learning that larger spill holes do in fact lead to faster descent rates, such that para- chutes with spill holes essentially behave like smaller parachutes. Rebecca's father, Bob Zurek, broke down the challenge of designing a B Cluster Altitude model into four key aspects (cluster configuration, motor pod design, motor retention and porting, and motor ignition). His study meticulously analyzed each of these four areas and arrived at an optimal or reliable solution for each, resulting in a model de- sign that performed very close to simula- tion. Thanks to everyone who entered R&D and to everyone who came to the presen- tations! We always see a good turnout of folks listening to the oral presentations and this year was no exception. This year's reports illustrate very well why there will never be an end to interesting rocketry re- search ideas. If you have been in the hobby for a little while and taken on any interest- ing projects, chances are you have already done a fair amount of R&D. Maybe next year you too can enter the formal compe- tition! Research and Development A Division Project Title 1 Massoni, Zackary Battle of the Four Nose Cones 2 Stenberg, Ryan Two String vs One String Streamer B Division 1 Zurek, Rebecca Hole-y Chutes! (parachute spill-hole testing) 2 Estrada, Ryan Youth Rocketeer Recruitment C Division 1 Flanigan, Chris Simulation and Testing of Rail Launchers 2 Zurek, Bob Designing Cluster Rockets for Altitude 3 Cieslak, John Development of the "Open Tower System" from Robotic Structures D Division 1 Neutron Fusion Magnetic Fit for Piston Launchers 2 Bumbling Brothers F.C. Reconstructing the Performance of a Congreve Rocket 3 Huh? What? Team Investigation of GNSS with RTK for Determination of Altitude of Model Rockets

