Issue link: https://www.e-digitaleditions.com/i/1220484
38 MARCH/APRIL 2020 SPORT ROCKETRY duration) transmissions. The pulse length is about 2 seconds, but as long as the but- ton is held down it will send repeated puls- es. The panel has 12 individual firing but- tons (along with "Sequence" and "Fire All" buttons) and a 00-99 selector wheel for the 12-pad cells, which gives it a total capacity of 1200 "cues" (pads). The DBR01-X has a rocker-type power switch, but a newer ver- sion has a removable key switch. The ef- fective range of the transmitter is 200 me- ters, as measured on the field, and runs on six AA batteries that will last hundreds of launch cycles. Pretty impressive for a $90 box! The receivers cost around $10 to $30, depending on the number of channels. A DBR controller with nine 4-cue receivers (36 total) cost about $120. With 4-chan- nel relay modules (see discussion below) included, the total system cost comes to around $270. Most online vendors of- fer several combinations of receivers with the controller, and the prices seem to vary quite a bit with no consistency, so one can shop around and find a good deal. All of the receivers use red/black spring-type terminals like those found on speakers. The 6-channel receiver operates with six AA batteries to provide 9V to the igniter terminals, whereas the other receiv- ers all use four AA batteries for 6V op- eration. While these power supplies will easily fire e-matches, bridge-wire igniters need 12 volts along with higher amperage for reliable operation. As the DBR receivers don't have a 12V external-power option, it was apparent that modifications would DBR System The DBR system consists of the DBR01- X wireless controller and several different types of receivers, which have 1, 2, 4, or 6 channels (Figure 3). FSA's low-power setup uses individual 6-channel AN06R receivers installed in boxes on two 6-pad sawhorse- type pads. The mid-power system uses a pair of 6-channel receivers in a range box that is placed in the center of the pad area, with individual 15-foot leads radiating out to the pads. The DBR01-X transmitter operates on 433 MHz, which is legal in the U.S. for low-power, pulse-type (less than 5-second Figure 6 (above). Wireless relay module pad box components. Figure 7 (below). Six-channel, 9-volt relay module.

