Issue link: https://www.e-digitaleditions.com/i/1220484
pointment early the next morning and when I started up my faith- ful Pinto. While waiting for it to warm up, I noticed steam coming from under the middle of the car. Opening the door I could see a puddle of wonderfully clean and clear water spreading outwards. Back then, I was not only cheap, but I must disclose, I also had the requisite volumetric dimensions to shimmy under the car to dis- cover what wonders lay beneath. Which I did. And there along the side of the engine block I could feel a ragged bulge seeping water. Clear, clean gluten- and glycol-free water. I missed my appoint- ment and instead bought a package of JB Weld. I couldn't see the extent of the break in the block, but having mixed up the goo, by feel alone, I packed it into the cracks as best I could, and waited two days. I filled up the radiator with water and ran that car for three more years with nary a hitch. When I left college, I sold that pony with a radiator full of anti-freeze. I love JB Weld. But I also hate JB Weld, because now I had to sand it off and it was going to be hard work. I leaned in and be- 30 MARCH/APRIL 2020 SPORT ROCKETRY Figure 9. The Point of Tangency is the very small contact point where a flat surface meets a curved surface. Why not use a soft sanding pad? While a soft pad will contour to the surface, that contour will also follow imperfections (see Figure 5) and will not leave a perfectly flat or circular surface. gan: Sand On, Sand Off, Sand On, Sand Off. I could feel a headache coming on so I lay down in order to think more clearly. At over half a century in age and with a good grasp of math, I was clearly not going to live long enough to get this done by hand. Even more clearly, I was not going to impress anyone at NARAM with JB Weld spiraled in a berm the size of the Hoover dam. I needed a better way. Clearly, I needed Superman! I tried taking a Lois Lane look-alike doll and giving it to the dog to chew on. Alas, Su- perman was a no-show. Continuing to recu- perate on the couch my brain registered that what I needed was some hardware. Mentally, I took inventory of all my sanding equipment. Having run a millwork manufacturing shop, there were readily at my disposal orbital sanders, vibration- Figure 11. The Festool custom block kit's single-use sticky hook-and-loop is adhered to the surface of the body tube and a sandpaper sheet is pressed on. Figure 10. The Custom backing-block kit. Hard-foam pad, glue, instructions, hook-n-loop sheets, mating hook-n-loop sheets, sanding sheets.

