Sport Rocketry

Sport Rocketry 2.2020

Issue link: https://www.e-digitaleditions.com/i/1220484

Contents of this Issue

Navigation

Page 49 of 55

50 MARCH/APRIL 2020 SPORT ROCKETRY four 2-inch pieces into the four openings of the cross. Make sure the pieces are all seated as deeply as possible into the joint (for this size PVC they should seat 1 1/4 inches deep, leaving a 3/4 inch end ex- posed), making sure that no excess glue is showing on the exposed ends. This will be the center of the launch pad. For those of you with little experience working with PVC, always apply the glue to the female side of any PVC joint, and do them one at a time as the glue dries quickly. When fin- ished you should have a PCV cross with 3/4 inch pieces of pipe sticking out each end. Next, glue one 45-degree elbow on each of the 28-inch lengths of PVC pipe. These will be the legs of your launch pad. By the time you're done with the legs, the glue on the cross should be dry. Drill a 7/16-inch hole all the way through the center of the cross as it lays flat. Do the same through the center of the sheet metal round. I recommend drilling a small pi- lot hole in each item first, as it will make things easier to hold while you drill. There are two ways to do the next part. One, you can either screw the hex bolt into the drill chuck, then saw the head off of the hex bolt. This will allow you to drop it through the sheet metal round (blast the pack rat that I am and that you're going to buy the drill chuck and the hex bolt for its spindle. As for the sheet metal round (for a blast deflector) I suppose you could use the top of a 3-pound coffee can in a pinch, but I'd be wary of the sharp edges and or warping potential caused by rocket ex- haust. I got everything else from Home De- pot (they have drill chucks for around $10 in the Tool Corral for you one stop shop- pers). Take the length of PVC pipe and cut three 28-inch lengths. Take the remain- ing piece and cut four 2-inch pieces. The remaining piece will be another 28-inch length. All totaled, you should have four 28-inch pieces and four 2-inch pieces. Set the long pieces aside and locate the PVC cross and PVC glue. Following the in- structions on the glue can, glue each of the by Ben Honeycutt NAR 75994 First of all, I'm thrifty (read as cheap). I enjoy model rocketry, but as the sole bread- winner in the family, I'm not too thrilled with the cost of this wonderful hobby. As I've graduated into mid-power birds I've found the standard Estes launch pad to be inadequate for larger rockets, and I had a case of sticker shock when I saw the prices of mid-power launch pads. Being a tinkerer (as well as cheap) I wanted to build a stur- dy, portable, and most importantly inex- pensive launch pad. I figure the less I spend on launch equipment, the more money I have to spend on the rockets. Now that I'm done with all my excuses, I guess I'd better explain how to build this thing. Nearly all of the materials needed are available at any well-stocked hardware store. The only exceptions for me were the drill chuck and key, which I got from an old burned out drill, and the piece of sheet metal, which was cut from the end of a 55-gallon drum. I'll assume you're not JonRocket.com Model Rocket Kits, Parts, Supplies, and Accessories (Left) Side view of all PVC parts assembled except the leg facing the reader. Building an Inexpensive PVC Launch Pad (Below) Detail of PVC cross with inserts and hole drilled. Drawings not to scale.

Articles in this issue

Links on this page

Archives of this issue

view archives of Sport Rocketry - Sport Rocketry 2.2020