Sport Rocketry

Sport Rocketry 5.2020

Issue link: https://www.e-digitaleditions.com/i/1283117

Contents of this Issue

Navigation

Page 38 of 55

with a new mnemonic, like "red bulkhead, up" means "better get the main packed correctly." Actually, the color scheme is not that big of a deal. I understand that differ- ent colors for the bulkheads are more im- portant than specific choices. Figure 8 shows the parts before as- sembly. The finished bulkheads are 0.245 inch thick, after machining a small amount off the faces for finishing, and weigh 127 grams each. The holes for threaded rods, U-bolts, and the sled fastener are clear- ance holes. David tapped the remainder of the holes so that the respective bolts can just thread into them. The only thing that I would do differently, besides getting the colors correct, is to thread the lower bulk- head for the ¼ x 20 threaded rods, instead of clearance holes. Figure 9a shows the CAD design of the main bulkhead. Figure 9b shows the 3D rendering. Figure 9c shows the assembled main bulkhead. Figures 10 and 11 show the completed avionics bay. I designed a tracker on a 3-inch length sled extension, which fits in an 11-inch length bay and SPORT ROCKETRY SEPTEMBER/OCTOBER 2020 39 can be removed for the 8-inch bay. I will replace the lock washers with jam nuts and Locktite Threadlocker Blue 242. The 3D printed sled is kept from rotating around the threaded rods by 4-40 nuts through the bulkhead. I found that 4-40 bolts do not hold tight enough threading into PETG sled. I drilled out the holes and glued in bushings that the bolts thread into for a stronger and tighter support. Summary of Features • 4-inch diameter bay configurable in 7.5-inch and 11-inch length sleds • Tinder Raptor CO 2 system on the main chute (Figure 2) • Eggtimer Proton and Quantum altimeter (Figure 12) • LabRat Rocketry pull switches Figures 5a and 5b. The machining process. Photos by David Fliger.

Articles in this issue

Archives of this issue

view archives of Sport Rocketry - Sport Rocketry 5.2020