Issue link: https://www.e-digitaleditions.com/i/1284149
18 I ICT TODAY Li-Fi's OPERATIONAL LIGHT SPECTRUM For Li-Fi technology, communication data information is provided through the following spectrum ranges: • Visible light wavelengths from 380 nm to 740 nm (430 to 770 THz light frequency) • Infrared light wavelengths from 700 nm to 1 mm (430 THz to 300 GHz light frequency) • Ultraviolet light wavelengths from 10 nm to 400 nm (8 × 10 14 Hz to 3 × 10 16 Hz light frequency) Because UV light has damaging effects on human health, only visible and infrared light spectrums are used in Li-Fi technology. This opens up 10,000 times greater bandwidth than existing Wi-Fi radio frequencies (RFs) on the visible spectrum only. Therefore, visible light spectrum is predominantly used. Options are also being explored using the invisible infrared light spectrum, since it is already being used to send information (uplink) back to the LED light bulb. Because light bounces off surfaces and light reflected from surfaces also carries data, Li-Fi is not strictly a line- of-sight technology. Rather, Li-Fi is a cellular communi- cation system, and the data rate is not dependent on the line of sight but on the signal quality at the device. Signal quality can be defined by the ratio of the desired data versus any interfering data and noise. It is also important to understand that Li-Fi is a bidirectional wireless communications technology that allows high speed transmission in both uplink and downlink simultaneously. LIGHT LEVELS FOR Li-Fi Light fidelity can operate in daylight and even in direct sunlight conditions, as the modulated light can still be detected. It relies on detecting the fast changes in light intensity and not on the absolute or slowly varying levels caused by natural disruptions in daylight or sunlight. Since sunlight is constant light and Li-Fi technology modulates the light at very high rates, the sunlight can be filtered out at the receiver. Outdoor receivers have been tested under 77,000 lux of sunlight (or 7,700 foot-candles [fc]). 4 As a reference, a brightly lit office is normally at 500 lux (50 fc). If all power to a light is turned off, then there is no Li-Fi. However, Li-Fi technology can be enabled to low enough light levels in a room that make it appear dark and still transmit data. There is consistent performance between 10 and 90 percent illumination. 5 Communications with Li-Fi's technology has been achieved at light levels down to 60 lux (6 fc). As a com- parison, the IESNA standard light level for reading is between 200 and 500 lux (20-50 fc). Lighting along a perimeter pathway around a building at nighttime is around 5 to 6 fc. Li-Fi SPEED As a dense and fast wireless communication technology, Li-Fi offers greater speed and density than RF solutions. The following notable achievements exemplify its evolution: • August 2013: Data rates of over 1.6 Gb/s were demonstrated over a single-color LED with an upstream communication rate of about 600 Mb/s. 6 • April 2014: A company from Russia developed a Li-Fi wireless local network module transferring data at 1.25 Gb/s, while striving to achieve up to 5 Gb/s. 7 • In 2014, a new record was established by a company in Mexico at transfer data speeds of up to 10 Gb/s across the light spectrum emitted LED lamps. 8 The high frequency of light/data transmission is undetectable to the human eye. The LED lights used to transmit Li-Fi signals are modulated at such a fast rate that the eye cannot perceive the modulation or flicker.

