Issue link: https://www.e-digitaleditions.com/i/1284149
22 I ICT TODAY INSTALLATION OF Li-Fi SYSTEMS In order to enable Li-Fi service in any building or exterior application, the utility front end internet service equip- ment is still required. Once service is provided at a build- ing and the high-speed connection is established, the Li-Fi network can be utilized to distribute internet service by using PoE or power line communications (PLC). All Li-Fi compatible drivers that power LED lighting need to be connected via minimum Cat 6A cabling or optical fiber to the head-end telecommunications equip- ment (e.g., patch panel, router, modem) depending on the number of lights that will provide the data signals to the drivers, which will then transmit the information to users in high-frequency. Category 5e and higher cables may also be used for the cabling structure between the utility provided signal equipment and the LED lights. However, the recommen- dation in TIA TSB-162 and the minimum requirement in ANSI/BICSI 008-2018, Wireless Local Area Network (WLAN) Systems Design and Implementation Best Practices is one Category 6A cable. Optical fiber cabling (OM3 or higher) or two balanced twisted-pair cables (Category 6A or higher) are recommended to support speeds higher than 10 Gb/s. WIRING INSTALLATIONS FOR Li-Fi NETWORKS There are three solutions for providing the cabling infrastructure for Li-Fi wireless communications: • Currently, PoE is the optimal solution for driving the network cabling structure and, therefore, the preferred option for new installations. • Power line communications is the preferred option for retrofit installations. PLC can be used for sharing the available capacity between lamps attached to any given circuit ring. • The "Cloud RAN" architecture can also help alleviate the pressure on the cabling infrastructure. However, the long-term cabling infrastructure is resolved by using PoE in new offices, which is proving to be more efficient for smart buildings and lighting. Some projects completed in Europe indicate numbers as high as 25 percent reduction in overall cabling installa- tion time and a "50 percent installation cost savings than the equivalent traditional installation." 15 The highest quality of lighting controls can be achieved by creating a network of addressable lighting. In order to accomplish this, minimum Ethernet Cat 5e cable or higher has to be run to each luminaire, although Cat 6A or higher cabling is recommended for achieving the higher uplink speeds of at least 10 Gb/s. The benefits of addressable lighting include the ability of creating lighting zones, which in turn allows for creation of lighting scenes, energy savings, and ease of troubleshooting. If lighting in general is also used to provide Li-Fi service, all cabling to devices become obsolete, unless the device is located outside of the Li-Fi light range where communication outlets may be provided. For the most part, devices tend to be in illuminated areas where people are able to see while they operate them. Based on this, the projects that would likely reap the reduction in cabling installation time and overall costs similar to the European projects would be those that originally intended to install addressable lighting. Adding addressable lighting to a project can be very expensive. It is mainly used in large projects where lighting addressability brings real value to daily opera- tions, such as at convention centers, theatres, hospitals, The highest quality of lighting controls can be achieved by creating a network of addressable lighting. airports, and large office buildings where new and different tenants need a different square footage almost every time they move in. With non-addressable lighting, wiring modifications are required, which could make the tenant improvement costs expensive. Addressable lighting would reduce this process to programming only.

