Issue link: https://www.e-digitaleditions.com/i/1302769
Navigation Lights and Airframe Final Assembly Thinking that the 1/8" diameter dow- el fin pods looked somewhat barren, I thought I'd spruce them up a bit with some navigation lights. To create these, I used the dome ends from a set of 3mm clear LEDs. Just about the perfect diameter. I chose clear LEDs, as while two of the domes would be tint- ed red and green, the third dome, the one to be located on the dorsal fin, would be ing care to avoid any contact with the painted surfaces. The advantage of contact cement in this application is the absence of any glue squeezing out the edges as the various appliances are pressed in place. It makes for a nice, clean installation. With this our airframe is now com- plete. In Part II, we'll tackle that cockpit. SPORT ROCKETRY NOVEMBER/DECEMBER 2020 39 Sport Rocketry is looking for full length feature arti- cles with high quality photos/illustrations. Articles such as building projects, technical topics, and "how to" sub- jects are needed Sport Rocketry is also looking for additional, short- er, perhaps less technical, but still substantive articles. Examples of shorter articles that have been published include: outreach events, local or regional launches, and simpler builds. Feature article authors will receive $350 after pub- lication of their article. Authors of shorter articles will receive a free year's NAR membership. Decision on pay- ment is based on the quality and subject matter of the article and is at the discretion of the Periodicals Com- mittee Chair, Mark Bundick. Do you know someone in your club or a NAR member attending your launch who has an interesting project or model you think would make a good article? Please send those suggestions, along with any contact information on the project owner, to Periodicals Com- mittee Chair, Mark Bundick for follow up. WRITE IT WRITE IT WRITE IT WRITE IT And Get Paid! And Get Paid! And Get Paid! And Get Paid! Crushed torpedo tube. Torpedoes, ready for finishing. Finished Starfighter photon torpedoes. ing surface to the airframe. With carefully placed dots of Weldwood Contact Cement, each landing and navigation light was in- stalled. With the nav lights now firmly at- tached, we can turn our attention to the mounting of the ordnance. Weldwood Contact Cement is used for this task, tak- clear, to represent one of the landing lights. Tamiya's X-25 Clear Green and X-27 Clear Red acrylic were the perfect tinting agents. Once the acrylic had dried, some care- ful sawing with a thin, fine toothed razor saw removed the domes from the LEDs. I placed the cut just in front of the semicon- ductor die. Each dome was then backed by a white disc punched from a sheet of Styrene; each disc was glued in place with the aid of Tamiya Extra Thin Cement. The white disc helps with light reflection within the dome, and its back side provides the glu-

