Issue link: https://www.e-digitaleditions.com/i/1302769
SPORT ROCKETRY NOVEMBER/DECEMBER 2020 41 Mike Moran, the inventor of the Chute Spool, provided me a sample of his BT-60 delayed parachute deployment device for testing and review. I had never held one of these in my hand or seen a launch using it. I chose a cast-off Big Bertha built by an- other modeler for my test vehicle. The Chute Spool design operates by having the parachute wrapped around a spool, with a wide ribbon wrapped over the parachute to hold in in place, and then a longer, thinner "delay streamer" is wrapped around all of that. The delay is determined by how long it takes the streamer and ribbon to unwrap during de- scent to release the parachute. It's a simple mechanical system, with no electronics. The version spool provided for testing uses a 3/16" wood dowel, 1/4" aluminum tubing, and plastic counting chips. In or- der to ensure that the rocket achieved suf- ficient altitude to allow the delay to de- ploy the parachute at sufficient altitude, I simulated the Big Bertha with the added 15 gram mass of the Chute Spool, allow- ing for the suggested 250-ft free fall after the engine ejection prior to parachute de- ployment. I didn't want to go too high as I wanted to test the spool in my backyard. Too much drift and there are large trees and a nearby pond which threatened to end testing prematurely. A simulation with an Estes B6-4 indi- cated that the rocket would only reach 63 m (207 ft) and hit the ground before para- chute deployment (2.95 seconds after ejec- tion). A simulation with a C6-5 projected a peak altitude of 155 m (509 ft). That Review by Kurt Gunther NAR 101713 Review: Mike Moran's Chute Spool Chute spool ready for prep.

