balanced look of it (Figure 7).
For the SRBs, the question for me is al-
ways the same: flush mount or standoffs?
But in the artist's rendering of the OmegA,
the SRBs are clearly well stood off. So in-
stead of using launch lug or running board
24 MARCH/APRIL 2021 SPORT ROCKETRY
Quickly Locate Your Downed Rocket in MINUTES!
Powerful Tracking Transmitters 2-9 Mile Ground
Tracking Range/10+ Mile Air Tracking Range
Lightweight Transmitters 2 Grams & up
Waterproof Circuits
Durable and Easily Transferred from Rocket to Rocket
Telemetry Specialists Since 1970
Receiver Models Tracking from 3 to 200 Rockets
Formerly Walston Retrieval
TRACK YOUR ROCKET
FROM LIFT OFF
TO LANDING!
1202 Walnut Street Murphysboro, IL 62966 800-842-4537 Toll Free
www.wmimodelaeronautics.com 618-687-3505 Fax: 618-687-3539 Email: mikec@caretrak.com
style standoffs, I tried a standoff attach-
ment I call the "shelf and post" method.
It's an asymmetrical standoff with a flat top
or "shelf" on which a post is glued. The
standoff is attached to the body tube and
then the SRB is mounted onto the post (a,
1/8" wooden dowel) through pre-drilled
holes (Figure 8). It made for a no fuss, no
muss way to accurately mount and align
the SRBs.
I used this on the 60 and it worked
out pretty good. At least, for a while. For
the first few launches of the 60, the flights
were straight and true. But on its most re-
cent flight, I noticed a squirrelly twist dur-
ing the boost. Upon examination, it was
clear that one of the SRBs had skewed and
was no longer aligned with the body tube.
It was fairly easy to remedy this, but I can't
be certain what caused it. With that in
Figure 8. The SRB mounting method
used on the OmegA 60. The dowels
are glued to the supports on the
exterior of the mail tube.
Figure 7. The six-fin arrangement used
in a previous SLS build (shown here)
is used on the OmegA 70.