Issue link: https://www.e-digitaleditions.com/i/1345417
sible. Onshape came to the rescue once again. While Onshape worked out well for my 3D nose cones, it could also generate 2D designs. I prepared some center- ing ring de- signs and up- loaded them to Sculpteo. com, an on- line laser cut- ting (and in- cidentally also a 3D print- ing) service. Shortly there- after my laser- cut centering rings were de- livered on my front porch. I ordered the c e n t e r i n g rings cut from 5mm thick plywood with delightful fit and precision (Figure 6). With the centering rings taken care of, I reached out to some of the great rocket- ry product vendors out there for finishing touches like standard motor mount tubes, fiberglass supplies, Kevlar cord, and rail buttons. Putting it all Together My first completed dumpster diving build was an 8.7-foot-long, 6-finned de- sign with a tapered transition between body tube diameters of approximately 3.5 to 1.5 inches. The lower, larger section of airframe was made from that burly, thick- walled tube that initially inspired me to take the dumpster plunge. Incidentally, the wall thickness was a ridiculous 0.25-inch and the completed build came in at about 8 pounds without a motor. No shock cord zippers happening in that sucker. The 3D printed nose cone and transi- tion took a good bit of filling and sanding to get the smooth surface that I was after (I was joining some slightly imperfect pieces into one nose cone due to my rookie-lev- el 3D printing skills at the time), but the work paid off and I finished with a glossy white and bright green paint job (Figure 7). I affectionately named the rocket Uncle Torch after my Dad (family inside joke). On November 3, 2019, Uncle Torch lifted off (thanks to the good folks at Tripoli Pre- fecture #094 METRA for hosting consis- 32 MARCH/APRIL 2021 SPORT ROCKETRY EXCLUSIVE EXCLUSIVE NAR MEMBERS NAR MEMBERS ONLY BENEFITS ONLY BENEFITS The NAR is constantly improving our website to bring additional benefits to our membership • Digital editions of Sport Rocketry magazine, 1993-2018 are available. • Digital editions of American Spacemodeling and The Model Rocketeer are available. • The Art of Scale Model Rocketry, by Peter Alway is available. • Extensive Technical Bibliographies, 1958 – Present are available. • Research and Development Reports, 1972 - Present are available. WWW.NAR.ORG/MEMBERS/ low parts (e.g., Alumilite 610 foam) with reasonable weight penalty. Now I needed some fins. Plywood, meet jigsaw. Done. The 3D printer also showed its ver- satility when I designed and produced canted fins for a spiral- ing flight profile (Figure 5). Why? Just for fun. Why else? Body tube: check. Nose cone: check. Fins: check. What about cen- tering rings? Again, I was up against non-stan- dard tube sizes for the outer diameters of my centering rings. I could cut them out of plywood along with my fins, but I wanted a high level of precision to make sure my mo- tor mounts ended up as straight as pos- Figure 7. Figure 6.

