Sport Rocketry

Sport Rocketry 2.2021

Issue link: https://www.e-digitaleditions.com/i/1345417

Contents of this Issue

Navigation

Page 32 of 47

tently great high-power launch events and witnessing my flight), flew to about 3,200 feet on an AeroTech J270 motor, free-fell to 1,000 feet with the aid of two redundant series-linked Jolly Logic Chute Releases, and safely landed under a 58-inch Apogee Components parachute (which took the brutal drogueless opening like a champ), earning me my NAR High Power Level 2 Certification (Figure 8). Reclaimed rocket #2 turned out to be the namesake for this article, D u m p s t e r Fire. I chose the name to honor the rocket's hum- ble begin- nings in the bottom of a bin of discard- ed cardboard. D u m p s t e r Fire airframe diameter was about 1.5 inches and I fitted it with a 29mm motor mount. The nose cone was 3D printed and filled with epoxy resin/ glass microballoons mixture. Due to the small difference between the body tube and motor mount diameters I crafted some- thing of a near-minimum diameter shock cord anchor using a small section tube, a piece of threaded rod, and some J.B. Weld epoxy (Figure 9). Dumpster Fire would ultimately wear a single layer of 3-ounce fiberglass overlain by an orange and black color scheme adorned with custom vinyl flame graphics and lettering from Sticker- shock23 (Figure 10). SPORT ROCKETRY MARCH/APRIL 2021 33 Dumpster Fire was followed up with a small yellow and metallic blue rocket made using my first 3D printed nose cone at- tempt. I also built Project Code Ninja from repurposed cardboard tubes as a tribute to the role that the good folks at Code Nin- jas played in getting these projects off the ground (Figure 11). Several other builds are in the works based around airframes that were destined for the card- board shred- der. Concepts under con- struction in- clude a 4-inch PAC-3 mis- sile (Figure 12), a 5-inch IRIS sound- ing rocket, a s p o r t - s c a l e orbital launch vehicle with four boosters (all made from r e p u r p o s e d tubes incor- porating a 3D printed elec- tronics bay), and a cluster rocket with a central 38mm motor mount surrounded by six 29mm mounts. Two formerly used triangular shipping tubes are about to be converted to a triangular airframe with a triangle pyramid 3D print- ed nose cone (Figure 13) and some very unconventional centering rings from a cus- tom laser cutting service. Clearly, some re- covered materials can lead to loads of rock- et building opportunities. Not only were those airframes saved from the scrap heap, but the cost savings for rocket building will be substantial. Figure 9. Figure 10.

Articles in this issue

Links on this page

Archives of this issue

view archives of Sport Rocketry - Sport Rocketry 2.2021