Sport Rocketry

Sport Rocketry 2.2021

Issue link: https://www.e-digitaleditions.com/i/1345417

Contents of this Issue

Navigation

Page 42 of 47

just sanded some of the old paint off and threw on a light coat of primer. I added some black paint for the roll patterns, taped them off, and finished with gloss white. Decals were printed on stock pa- per, applied them with Mod Podge, and sprayed them with a clear coat. I have included a picture of the fin- ished rocket at our club launch alongside my other SLS build. It looks pretty good, ing, requiring me to be creative as well as resourceful. But the best part of this was something I didn't expect at all: the old fondness I had for the Sabre and the Soyuz was rekindled, as they gained new life, fly- ing again in the new rockets. Do you have a couple of old rockets just sitting in the dustbin? Revitalize your fleet! Reuse, rebuild, and refly. You may be pleasantly surprised with the results. SPORT ROCKETRY MARCH/APRIL 2021 43 The SRBs will be mounted on small standoffs. The new parts that were needed: BT-20 tubes and nose cones for the SRBs—less than $5.00. right? It turned out better than I antici- pated. Look closely and you can see the original strakes, the coupling joint, and the black stripes hiding the blemishes from the fin reduction. For its first flight I certainly was anxious. But the rocket flew straight and true. With a majestic boost, the rocket arced ever-so-gingerly to 968 feet. Not too shabby! Since then, I've named this rocket the SLS Cargo. It's become one of my fa- vorite rockets, already logging six success- ful flights. And remember, this build only cost me $4.80 But what about the leftover parts from the Soyuz and the Sabre? I built another rocket with them that I use as a test ve- hicle. I constructed it to have a stability factor of two calibers when flying with the Chute Release or other similar payloads. I trimmed back the fins in the event there may be some hard landings. But I didn't put a lot of work into it, because after all, it is a test vehicle. All in all, this endeavor was quite en- joyable for me. It certainly was challeng- Top part of the completed SLS Cargo, with the BT-70 payload section. Tube cut is obscured by roll pattern. Bottom part of the completed SLS Cargo. The bottom of the Soyuz 70 and top of the Sky Sabre were united into a new test vehicle.

Articles in this issue

Links on this page

Archives of this issue

view archives of Sport Rocketry - Sport Rocketry 2.2021