Issue link: https://www.e-digitaleditions.com/i/1345417
Since this rocket is for 1/2A and has the Adrel altimeter in the nose, it is over sta- ble. Open Rocket reported an altitude of 165 meters. Very close to my actual flight. I was expecting 20% to 30% more since I was using a piston. That would have put the flight in the 200-meter range. A simu- lation showed that ejection actually occurs before apogee but Open Rocket doesn't stop the ballistic flight path. So perhaps my piston did help a little. It is also likely that the ejection occurred earlier than the simulation shows. The simulation assumes the full 4-second delay for the 1/2A3-4T. Estes delays usually run short. NAR S&T data shows the actual delay of the motors tested was only 3 seconds. With the mo- tor burn turn time that means ejection oc- curs at around 3.4 seconds in flight, and per the simulation the rocket would be at an altitude of 145 meters. So, assuming the simulation has an accurate model of my rocket, there is a piston benefit of around 13% (also assuming not much altitude in- crease after ejection). Of course the simu- lation may be more optimistic about the drag on my rocket. I selected "polished" finish (least drag) in the sim. Switching to "smooth paint" from polished lowered 14 MARCH/APRIL 2021 SPORT ROCKETRY Figure 1. Adrel ALT-BMP altimeter next to nose cone section of the 13mm rocket that will hold it. JonRocket.com Model Rocket Kits, Parts, Supplies, and Accessories the basic problem with my original design was that it was way too heavy and draggy. The simulations showed that even with the settings at "polished finish," you would not break 200 meters with a rocket that weighed 14 to 16 grams (full up launch ready). Once the mass was reduced to 12 grams or less, it appeared to be viable. Of course the X factor is how much extra alti- tude you can get from your piston that the simulation doesn't show. I had thought a good piston could result in a higher flight than RockSim predicts by as much as 30%. But both my and Tom's piston-flown rock- ets didn't go much higher than the simula- tions. After that meeting, my "Operation 200 meters" began. I was determined to join National Scoreboard leaders Steve Krystal and Glenn Feveryear in the "200 meter high club." My original design is the white rocket in Figure 3. A 7" 13mm body tube and 15 mil thick G10 elliptical fins. Root chord of the fins was 1" and the span 1.25". Open Rocket showed a stability margin of 2 cali- bers. Way over stable. The reason is I had started from an A Altitude plan with no altimeter that I placed with at NARAM-45. Figure 2. Adrel ALT-BMP now fully installed in the nose cone with extended shoulder.

