Issue link: https://www.e-digitaleditions.com/i/1220484
SPORT ROCKETRY MARCH/APRIL 2020 29 and I simply couldn't imagine there being any of the Mach-one-perturbed Mr. Elmer left. So I sanded him all off. After I recovered from that setback I decided that the best filler would be an epoxy. But which one? After some experimentation I settled on JB Weld. It sticks like the dickens and can bear a glossy surface. Before going a baby-step further, I want you to know that that decision was one of my worst. I should have used Fix-It clay epoxy. Fix-It sands like Ice Cream in the hot sun compared to JB Weld. The best that I can figure is that JB Weld is a living substance and each molecule hugs its neighbor-molecule for dear life and won't let go under any circumstance. Each molecule can only be sanded away from The Collective when its dearly hugging neighbor lets go for a fraction of a second to go to the bathroom. Which they only do once per week. So there I was with two 24-inch tubes 3D en- hanced by generously filled-to-overflowing spirals (Figure 6). The process of spreading and filling is also often a messy one, so drips and runs and threads me- andered all about the cylinders. No worries, just sand them off. The lesson learned here is that BlueTube sands considerably faster and more readily than JB Weld. Let me tell you something about JB Weld. When I was in college in Tennessee, I had a Ford Pinto. I was a cheap guy back then and didn't want to spend even a penny on anti-freeze. I was saving all my money to give to Tim. The forecast one particular night was for a freeze, and with that the die was cast. I had an ap- Figure 6. JB Weld spirals being sanded. The BlueTube is losing in this battle against the JB Weld. This is where I gave up the manual effort. I really don't like sanding. Really. Figure 8. A custom block for wood moulding; a custom block for 4" rocket body tubes; a fresh block ready to customize. Figure 7. Festool Linear Sander. The desired backing-pad clips to the bottom shoe. Figure 5. A soft sanding pad will squish into the grooves thereby sanding out the filler, rather than sanding it flush.

