Sport Rocketry

Sport Rocketry 2.2021

Issue link: https://www.e-digitaleditions.com/i/1345417

Contents of this Issue

Navigation

Page 29 of 47

the resin available and he was kind enough to order the glass micro-balloons for me. I decided I could use epoxy resin (specifi- cally Alumilite Slow Set 15) to reinforce my 3D printed parts, and for larger parts I could use good old fiberglass layup tech- niques over 3D printed casts or molds. The Alumilite resin turned out to be very hard and damage-resistant and I also found that I could embed a Kevlar cord loop in the nose cone while the resin was still uncured, resulting in a very solid shock cord mount. 30 MARCH/APRIL 2021 SPORT ROCKETRY Structural two-part foams are also an op- tion for reinforcing hollow parts, but with less weight than an epoxy resin. In my de- structive test (some intentional, some ac- cidental) I found that high expansion ra- tio foams didn't add much toughness to a part but higher-density structural foams did very well in impact tests. The struc- tural foams are between the Slow Set cast- ing resin with microballoons added and the high expansion ratio foams in density (and therefore in final weight of the part). I have experience with Alumilite products but there are other vendors worth explor- ing (e.g. Smooth-On, Reynolds Advanced Materials, TAP Plastics). Making it Happen After working out 3D printing tech- niques, learning some basic 3D computer- aided design, and reassuring myself that the 3D parts I ended up with would be strong enough to handle my rocketry ap- plication, it was time to pull the trigger on a 3D printer. My printer arrived and I started small, printing a nose cone for a repurposed small carpet tube about 1.5 inches in diameter (Figure 3). I was quite pleased with the result, but getting my larger prints to come out with the level of quality I was after proved to be a learning process. Since the build volume of my 3D printer was relatively small (I went with an inexpensive Anycubic Photon resin-based system as opposed to the more common filament-based systems) I had to break up larger nose cones into smaller pieces, then epoxy them together or join them with cyanoacrylate glue (Figure 4). Once individual components are pieced together any warping or disfiguring in the parts be- comes painfully obvious. I experimented with print support structures, printer set- tings, and post-cure duration times to im- prove my results. After extensive "trial-and-learning" I was cranking out parts reliably that could be forcibly thrown at a concrete floor and survive without cracking. With my specific printer slicing software I learned that sup- port structures are best added manually because the auto-support feature in the software will often add the structures to a nose cone shoulder such that the support is fused to the shoulder wall and can't be easily removed, leading to tedious grinding and sanding. I also found that, through re- search and experimentation, that post-cure time when using resins for 3D printing is Figure 2. Figure 3. Figure 1.

Articles in this issue

Archives of this issue

view archives of Sport Rocketry - Sport Rocketry 2.2021