Machinery Lubrication magazine published by Noria Corporation
Issue link: https://www.e-digitaleditions.com/i/1171112
COVER STORY word to remember: COPPER, which stands for contaminated oil, proactive practices, eff ective results. e reason "COPPER" was chosen is because copper is a contaminant in the facility's oil. e goal is to remember that if personnel are proactive in preventing contamination, this will lead to more eff ective maintenance results. To aid in better storage and handling prac- tices, a set of rules was created to prevent oil mishandling and contamination. e current rules include the following: 1. Do not mix diff erent types of oil. Verify which type of oil is needed for each application and then use the correct or provided handheld container in the oil storage shed. 2. When replacing oil, only drain into buckets and containers clearly marked for "used oil." ese are located in area No. 5 within the vacuum waste tote storage areas. No used oil should be stored in the oil storage shed at any time for any reason. 3. Do not use any provided handheld container for used oil if it is intended for new oil and located in the oil storage shed. 4. Only use the trash pump to pump used oil. Never use any other fi lter pump to assist in draining out used oil. 5. Always ensure the funnel, new oil container and area around the opening to each piece of equipment are clean and free of any foreign debris when refi lling new oil. 10 | September - October 2019 | www . machinerylubrication.com quick connect and sampling tube. e tube goes directly into the gearbox and can be bent upward so the sample is taken away from the bottom and side sediment for a more represen- tative sample. e quick coupling still permits draining, but it also allows a permanent connection to a fi lter cart. e other piece of the assembly is installed into the breather port. is piece includes an area where a desiccant breather and another quick connect can be installed for fi lling or connecting to a fi lter cart. The mounts worked great. In-service fi ltration was able to be completed and with a much better method of extracting oil samples. Once the 30-day testing period was over, Briner obtained purchasing approvals from the maintenance team. By the end of 2017, all the vital equipment had been fi tted with these mounts. e mounts and expedited oil analysis reports improved the success and completion of work orders. Because Briner was receiving reports faster and understood them better, he could create work orders for the PM task team to complete. Before the drain and breather mounts, they had to schedule work alongside the production schedule to determine when these vital pieces of equipment could be taken out of service for fi ltering. As mentioned, sometimes the work could not even be completed before the next oil sample. Now, because these mounts with quick couplings are already on the machines, the team can simply hook up the fi lter cart and come back in a couple of hours. T he se mou nt s were t he big ge st gamechanger of all the improvements. With the fi rst three major items on Briner's list crossed off , he began working on the other improvement items. REDUCING CONTAMINATION Reducing oil contamination has been a continuous improvement process. Advanced Composites fi rst had to educate and train its team on ways to prevent contamination. Briner introduced "maintenance touchpoints," which are handouts that are reviewed by all team members, discussed, signed and then fi led away in the training folder. Within the maintenance touchpoint, Briner gave one The drain mount (left) and breather mount (right) installed on a vital piece of equipment The fi lter cart connection on one of the breather mounts

