Issue link: https://www.e-digitaleditions.com/i/1544305
16 April 2026 Inhalation e pipe sections with the sampling ports for the stagnation temperature and pressures (items 3 and 7) are the same as those described in a previous study [15]. e overall lengths of the upstream and down- stream sections are approximately nine inches and six inches, respectively (15 and 10 pipe diameters). e pipe inside-diameter is 0.62" (size 12AN). Each of the sampling ports is an annular sampling manifold (six taps, 60 degrees apart), known commonly as a piezometer ring, which ensures the P and T measure- ments are the stagnation values. e chosen down- stream pressure transducer (item 8) measures the differential pressure relative to ambient pressure, and the ambient pressure is monitored before and after the test with the Mensor Model CPT6020 absolute Table 1 identifies each component of the appara- tus in Figure 2. When testing a valve (item 6, Table 1), ambient air is drawn with a vacuum pump, first through an in-line HEPA filter and a flow meter and then into a straight pipe that allows for measurement of the stagnation temperature and the stagnation pressure upstream of the valve under test. Downstream of the valve under test, there is another section of straight pipe and a sampling port for the stagnation pressure. e air then passes through a second valve, but one with significantly larger flow capacity than the valve under test. is larger valve allows the oper- ator to adjust the mass flow rate of air drawn through the system. Finally, the air leaves the apparatus by way of the vacuum pump and returns to the surroundings. Item Number Item Name Manufacturer or Supplier 1 HEPA Filter Model BB50T Breathing Circuit Filter, Global Life Sciences Solutions USA, LLC, Marlborough, MA, US 2 Mass Flow Meter Model 4043, TSI Incorporated, Shoreview, MN, US 3 Upstream Sampling Fixture Flow Systems Inc., Berthoud, CO, US 4 Stagnation Temperature Sensor Model P3A-NPT4-125-PX-0.5-PFSB-72-STWL, Evolution Sensors and Controls, Mullica Hill, NJ, US 5 Upstream Stagnation Pressure Transducer (P 1 ) Model CPT6020, Mensor LP, San Marcos, TX, US 6 Valve Under Test Model 8FV12LN, Parker Hannifin Corporation, Jacksonville, AL, US 7 Downstream Sampling Fixture Flow Systems Inc., Berthoud, CO, US 8 Downstream Stagnation Pressure Transducer (P 2 ) Part Number 2000-75KPA-AHU2, Dwyer Instruments, LLC, Michigan City, IN, US 9 System Control Valve Part Number 18RS8, Swagelok Company, Solon, OH, US 10 Vacuum Pump Model VT 4.8, Becker Pump Corporation, Cuyahoga Falls, OH, US Table 1 Components of Valve Testing Apparatus Figure 2 Laboratory equipment for testing flow control valves P 2 Valve Under Test P 1 1 2 3 4 5 6 7 8 9 10

