Issue link: https://www.e-digitaleditions.com/i/1067339
14 January 2019 Tablets & Capsules top of the cap dome. An excessive gap allows the cap to travel up and out of the stabilizing walls of the tooling, which can cause the cap to rock from side to side and col- lide with the capsule body during closing, as shown in Figure 1a. A small gap allows the cap to move very slightly, for self-centering as the body enters the cap, but keeps the cap from rocking laterally (Figure 1b). You establish this gap by placing a feeler gauge between the top of the cap dome and the bottom surface of the counter bearing. The appropriate gap for most products is between .13 and .50 millimeter. A good prac- tice is to start with a gap of .33 millimeter and then, if cap tucks occur, make small adjustments to determine the best gap for your product. If you're experiencing cap tucks, use the following adjustment pattern to fine-tune your counter-bearing gap to your product. Your com- pleted notes may look similar to Table 1. 1. Measure and write down the current gap setting. 2. Quantify the current defect level by running the turret one revolution and then inspecting the cap- sules produced. Write down the number of defects next to your note of the gap setting. 3. Adjust the gap setting higher or lower in increments of .05 millimeter and then run one turret revolution at a time, counting the defects at each setting. 4. Perform these steps until you identify the ideal set- ting for your formulation. Please note that you should reestablish this gap when switching from one lot of capsules to another. All cap- sule suppliers have an acceptable range for the cap length. For example, a size 0 capsule may have a cap length specification of 10.85 millimeters ±.35 millime- ter. If you switch from one lot of capsules with lengths at the lower end of this acceptable range to a different lot of capsules with lengths at the higher end of the range, you may need to adjust the counter bearing. You Figure 1 Adjusting the counter-bearing gap a. Excessive gap between cap dome and counter bearing allows cap to rock laterally b. Appropriate gap between cap dome and counter bearing keeps cap aligned vertically with capsule body Closing pin Counter bearing Upper tooling Lower tooling Appropriate gap Counter bearing Upper tooling Lower tooling Closing pin Excessive gap Cap/body collision Gap setting (millimeter) Sample size Number of defects .33 1,000 7 .38 1,000 9 .28 1,000 3 .23 1,000 0 Table 1 Fine tuning the counter-bearing gap Photo 1: This photo shows caps from two different capsule suppliers seated in tooling (IMA Zanasi 40). Note the difference in cap length. Switching between these two capsules would require adjustment to the counter bearing to prevent cap tucks.

